I've created three new stencils for my gelli plate.
The roll of acetate was proving difficult to flatten so here's a few more tips:
Tip of the day No. 1: Do not try to flatten acetate roll by pouring boiling water over it - your stencil will buckle and you will cry.
Tip of the day No. 2: You can try to iron out the buckling and flatten the stencil but start off on the lowest heat and have a tea towel folded in half with the acetate stencil in the middle.
Tip of the day No. 3: Buy acetate sheets if they are available. They may be more expensive than the roll but they are a better size but seriously all the bother and difficulty is not worth $1. (The roll was $5 = 500mm x 550mm/20 x 22 inches and the sheets are $3 = A3 = 2 x A4 = 29.7 x 42.0cm, 11.69 x 16.53 inches. Its area is 0.125 square meters, or 0.15 square yards,1.35 square foot, 193.75 square inches.)
The previous stencil inspired me to create this fish one:
This stencil I had thought about but then found something I had in mind on Pinterest - so I made some changes and added a few more bridges.
What am I going to do with all these prints? I'm going to package them up and sell them on Etsy! They'll be in the shop early next week, I need to create a few more to fill up the envelopes!
PS Do you love creating gelli prints? Want a place to discuss gelli printing? To show off your work? Share your ideas? Discuss the pros and cons of different paints/paper/plates/tools etc? Get some great ideas on what to do with the thousands of prints you have created?
Inspire and be inspired as a part of the Gelatin Printing Enthusiasts Facebook Group. I would love for you to join me there.
The roll of acetate was proving difficult to flatten so here's a few more tips:
Tip of the day No. 1: Do not try to flatten acetate roll by pouring boiling water over it - your stencil will buckle and you will cry.
Tip of the day No. 2: You can try to iron out the buckling and flatten the stencil but start off on the lowest heat and have a tea towel folded in half with the acetate stencil in the middle.
Tip of the day No. 3: Buy acetate sheets if they are available. They may be more expensive than the roll but they are a better size but seriously all the bother and difficulty is not worth $1. (The roll was $5 = 500mm x 550mm/20 x 22 inches and the sheets are $3 = A3 = 2 x A4 = 29.7 x 42.0cm, 11.69 x 16.53 inches. Its area is 0.125 square meters, or 0.15 square yards,1.35 square foot, 193.75 square inches.)
The previous stencil inspired me to create this fish one:
This stencil I had thought about but then found something I had in mind on Pinterest - so I made some changes and added a few more bridges.
What am I going to do with all these prints? I'm going to package them up and sell them on Etsy! They'll be in the shop early next week, I need to create a few more to fill up the envelopes!
PS Do you love creating gelli prints? Want a place to discuss gelli printing? To show off your work? Share your ideas? Discuss the pros and cons of different paints/paper/plates/tools etc? Get some great ideas on what to do with the thousands of prints you have created?
Inspire and be inspired as a part of the Gelatin Printing Enthusiasts Facebook Group. I would love for you to join me there.
No comments:
Post a Comment
All comments moderated. Please leave a comment after the beep....beeeeep...